Hello, dear friend, you can consult us at any time if you have any questions, add  WeChat:  zz-x2580

7304ENG Advanced Reinforced 

Prestressed Concrete Major Design Project Design of a Four-Storey Block of Units Introduction 

You are required to put your Concrete Design skills into practice when a local engineer asks 

you to undertake a preliminary design on a four-storey block of units. 

The structure is composed of reinforced concrete slabs, beams and columns with concrete infill walls.

 Attached is a layout of a typical floor and typical sections, from which you are required to produce your preliminary design. 

Task 1. Moment analysis can be performed using Strand 7 or any other software of your choice. 2. 

Using design guidelines given in the Australian Concrete Structures Standard – AS3600 you are required to design: 

 Typical Balcony and Floor slab (includes thickness and reinforcement layout) - Typical T-beams and Edge beams 

Columns (includes middle, end and edge column calculations) - Typical footing - Stair-way design (optional) Note that typical loading and Design guidelines are to be taken from AS3600. 3. You should use normal strength concrete (32 MPa) for the slabs and beams, and high strength concrete (80 MPa) for the columns. 4. It is desired that you use 500N steel as reinforcement. Where possible, use R10 plain round bars (fsy = 250 MPa) for stirrups and ties and N-bars not greater than 36 mm in diameter are to be used for beam and column reinforcements. 5. Designs should be for strength and serviceability limit states. Checks for durability would be desired. 6. You are required to also produce working drawings. Make sure you allow for development lengths where required, and provide appropriate detailing of reinforcement. 7. You can take the ultimate soil bearing capacity for foundation design as qu = 400 kPa. 4 m 4 m4 m4 m4 m 4 m1.5m 1.5 m 4. 25 m 4 m 4. 25 m 4. 25 m 10 .5 m 10 .5 m 10 .5 m Typical Floor Plan Stair case in between exactly same floor plan above this plan 5. 5 m Elevation (Note: The horizontal span length= 3.7 m, 3.8 m, 3.9 m, 4.0 m (as shown), 4.1 m. Students will be notified by email of the specific length to be adopted.) Australian Standards Download Link:  It is suggested to print them out after downloading as the pdf files expire after a few days. Weighting: 55% Due date: Project is due in Week 13, Friday (11:59 pm) 22 October 2021.